Fax Over Ip Codec Setup - NEC SL1100 Programming Manual

ISSUE 4.0
Program 84 : Hardware Setup for VoIPDB
Level:
IN
(This Program is available for V4.0 or higher)
Description
Use Program 84-32 : FAX Over IP CODEC Setup to program the CODECs used when faxing across
SIP Trunk. Note these settings must match in both systems for faxing across SIP Trunk to work.
Input Data
Item Item
No.
01 FAX CODEC
02 Payload Size
03 Jitter Buffer Mode
04 Jitter Buffer (min)
05 Jitter Buffer (average) 0 ~ 300
06 Jitter Buffer (max)
07 RTP Payload Type
Conditions
None
Feature Cross Reference
• Voice Over Internet Protocol (VoIP)
Programming Manual

84-32 : FAX Over IP CODEC Setup

Input Data
1 = G.711 a-law Set up FAX over IP CODEC.
2 = G.711 u-law If set to 4 [T.38 (UDPTL)], system does not
3 = G.726 follow PRG 84-32-02 ~ 07.
1 ~ 4 (10 ms base) Set up payload size when using SIP
Trunk.
1 = Static Set up Jitter Buffer settings when using
2 = Self adjusting SIP Trunk.
0 ~ 300 Set up minimum Jitter Buffer settings when
using SIP Trunk.
Set up average Jitter Buffer settings when
using SIP Trunk.
0 ~ 300 Set up maximum Jitter Buffer settings
when using SIP Trunk.
0, 2, 8, 96 ~ 127 Set up RTP Payload type when settings
when using SIP Trunk.
When the G.711 a-
This setting should be used as default.
law is selected in
Item 01, it is possi-
ble to set "8".
When the G.711 u-
law is selected in
Item 01, it is possi-
ble to set "0".
When the G.726 u-
law is selected in
Item 01, it is possi-
ble to set "2".
Description
SL1100
Program
84
Default
2
2
1
20
40
80
103
2-527