Sony HDW-F500 Maintenance Manual page 41

2. Connect the connector CN420 on the RM-130 board at the back of the ornamental panel to the
connector inside the unit whose OP panel was removed.
3. Fix the ornamental panel to the connector panel with the four screws removed in step 1.
4. Connect the BKDW-509 to other controllers via a 50-pin D-sub connector (male) during use.
Notes during installation
Pay attention to the following during installation.
. Note to install the RM-130 board avoiding incorrect insertion.
Insert the connector CN420 without removing its socket when the RM-130 board is installed an
incorrect-insertion prevention guide.
. Turn off and on the power whenever the input/output pin setting is changed.
When the input/output pin setting is changed, be sure to turn off and on the power after saving data.
If not, the VTR operation may become unstable.
HDW-F500E MMP1
Connector panel
Ornamental panel
(Backside : RM-130 board)
Connector guide
CN420
BVTT3 x 6
1-7. Installation of Optional Boards
1-31