Sony HDW-F500 Maintenance Manual page 97

Possible causes:
. S side or T side reel motor defective.
. S side or T side reel motor drive circuit (DR-307 board) malfunction.
. S side or T side FG waveform shaping circuit (DR-307 board) malfunction.
. Capstan motor defective.
. Capstan motor drive circuit (DR-307 board) malfunction.
. Capstan FG waveform shaping circuit (DR-307 board) malfunction.
. S side or T side reel brake defective.
. S side or T side reel brake solenoid drive circuit (DR-307 board) malfunction.
. Servo adjustment is faulty for reel, capstan or S side tension sensors.
. Height adjustment is faulty for reel table.
. Cassette compartment defective or installation of it is faulty.
(The reel stopped rotating because of the rising of the cassette tape from its reference
position.)
. Clearance adjustment is faulty for S side or T side reel FG detection block.
. Winding torque problem during rewind because of malfunction of the S tension sensor or
tension detection circuit (DR-307 board).
. Trouble of tape path, drum and the same.
. Tape trouble (problem of rewind state).
. Disconnection of harness.
Protecting operations:
The protection mode is selected, and search, fast-forward or rewind operations are stopped.
n
Be ensure to remove the cassette tape with your hand, after turning the power OFF.
If the power is turned ON again without removing the cassette tape, the tape may be dam-
aged.
(Refer to "2-12. Removing the Cassette Tape When Tape Slack Occurs".)
HDW-F500E MMP1
3-2. Error Messages
3-5