Powering On From The Cpu Blade; Powering On From The Network Serial Port - NEC N8405-013F User Manual

Powering ON from the CPU blade

Press the POWER switch on the panel of the CPU blade (the POWER/SLEEP lamp on the CPU
blade goes on green).
IMPORTANT:
unit is removed.
POWER/SLEEP
lamp
N8400-020F/021F/022F CPU blade

Powering ON from the Network Serial Port

Depending on the BIOS setting of the CPU blade, the power of the CPU blade may be automatically
turned on by a proper packet received from the network or via the modem connected to the serial
port.
This power-on procedure can be specified by setting [Wake On Events] of [System Hardware] in the
BIOS SETUP Utility. For more information, refer to the User's Guide of the CPU Blade.
Do not remove the front fan unit while the rear fan
POWER switch
POWER/SLEEP
lamp
N8400-013AF/014AF/017F/018/019F CPU blade
67
POWER switch