Table of Contents
Advertisement
Failure to Eject the Disk
When you fail to eject the CD-ROM tray with the Eject button and take out the CD-ROM from the
blade assembly unit, follow the procedure below.
1.
Shutdown the OS, and press the POWER switch to power off the unit. (The POWER lamp
goes off.)
2.
Insert a metal pin of approximately 1.2 mm in diameter and 100 mm in length into the
emergency hole on the right front of the CD-ROM drive. You can use a straightened large
paper clip as a substitute. Then gently push it in until the tray is ejected.
IMPORTANT:
Do not use a toothpick or plastic stick that could easily break.
If the above procedure does not let you take out the CD-ROM,
contact your service representative.
3.
Hold the tray and pull it out.
4.
Take out the CD-ROM.
5.
Push the tray back into position.
Emergency hole
71
Advertisement
Table of Contents
