Table of Contents
Advertisement
Connecting Hardware Devices
9
Position the rails on the auto loader and secure with two screws.
HINT: There are three types of predrilled holes on each rail. In most cases you will
use the round holes when securing the rails to the auto loader.
Attaching rails to the auto loader
10
Position the auto loader half-way into the empty device bays, then connect the power
and signal cables.
11
Slide the auto loader into the device bay until the rail latches click, indicating that the
device is locked into position.
CAUTION: Be careful not to pinch any cables as you slide the auto loader into
position.
Inserting the auto loader
12
If your server is equipped with an EPS-R power supply, reinstall the exhaust fan
module removed in step 2. For instructions, see
exhaust fan
13
Reinstall the access panel, reconnect all signal and power cables, then turn on the
server. For instructions, read steps 7 through 10 in
53.
on page 60.
Installing extended depth devices
Removing and replacing the primary
Maintenance overview
83
on page
Advertisement
Table of Contents
