Husqvarna AUTOMOWER 315 Operator's Manual page 26

Boundaries within the working area
Use the boundary wire to isolate areas inside the working
area by creating islands around obstacles which cannot
withstand a collision, for example flowerbeds, bushes and
fountains. Lay the wire up to and around the area to be
isolated, and then return it back along the same route.
If pegs are used, the wire should be laid under the same
pegs on the return route. When the boundary wires to
and from the island are laid close together, the robotic
lawnmower can drive over the wire.
IMPORTANT INFORMATION
The boundary wire may not be crossed on
its way to and from an island.
Obstacles that can withstand a collision, for example,
trees or bushes taller than 15 cm, do not need to be
isolated with the boundary wire. The robotic lawnmower
will turn around when it collides with this type of obstacle.
It is recommended to isolate all fixed objects in and
around the working area. This results in the most
gentle and silent operation and prevent the robotic
lawnmower from getting stuck in the objects under
any circumstances.
Obstacles that slope slightly, for example stones or large
trees with raised roots, must be isolated or removed.
Otherwise the robotic lawnmower can slide up onto this
kind of obstacle causing the blades to be damaged.
Secondary areas
If the working area consists of two areas which the
robotic lawnmower has difficulty travelling between, it is
recommended to set up a secondary area. Instances of
this are 40% slopes or a passage that is narrower than
60 cm. Lay the boundary wire then around the secondary
area so that it forms an island outside of the main area.
The robotic lawnmower must be moved manually
between the main and secondary area when the lawn
in the secondary area has to be cut. The Secondary
area (A) operating mode must be used as the robotic
lawnmower cannot travel on its own from the secondary
area to the charging station. See 5.1 Operation selection
Start on page 40. In this mode, the robotic lawnmower
will never look for the charging station but will mow until
the battery runs out. When the battery is flat, the robotic
lawnmower will stop and the Needs manual charging
message will appear in the display. Then place the robotic
lawnmower in the charging station to charge the battery.
If the main area has to be cut straight after charging, the
START button must be pressed and the Main area (B)
selected before closing the hatch.
English - 24
OM_1157863-26_HQ 310,315,EN_160229.indd 24
INSTALLATION
A
B
3023-005
3012-686
3012-1319
3023-006
2016-02-29 10:51:46