Husqvarna AUTOMOWER 315 Operator's Manual page 49

PIN request
This function means that the robotic lawnmower requests
a PIN code each time the hatch is opened. The correct
PIN code must be entered to use the robotic lawnmower.
Alarm
This function means that an alarm sounds if the PIN code
is not entered within 10 seconds after the STOP button
has been pressed or the robotic lawnmower has been
lifted up for any reason. A ticking noise indicates that the
PIN code must be entered to prevent triggering the alarm.
The alarm can be turned off at any time by entering the
correct PIN code.
Advanced
New loop signal
The loop signal is randomly selected to create a unique
link between the robotic lawnmower in question and the
charging station. In rare cases, there may be a need
to generate a new signal, for instance if two adjacent
installations have a very similar signal.
1. Place the robotic lawnmower in the charging
station to which the robotic lawnmower is to
be connected.
2. Select New loop signal in the menu and press OK.
Press OK and await confirmation that the loop signal has
been generated. This normally takes about 10 seconds.
Change PIN code
Enter the new PIN code and press OK. Confirm by
entering the same code again and pressing OK. When
the PIN code is changed, the message PIN code changed
appears in the display momentarily.
Make a note of the new PIN code on the designated line
in Memo on page 2.
Duration of alarm
When Alarm is activated there is also the possibility to
select how long the alarm signal should last. A figure
between 1 and 20 minutes can be selected.
Duration of time lock
A time lock can be set to decide how many days will pass
before the PIN must be entered before use. 1-90 days
can be selected.
OM_1157863-26_HQ 310,315,EN_160229.indd 47
MENU FUNCTIONS
English - 47
2016-02-29 10:52:13