Husqvarna AUTOMOWER 315 Operator's Manual page 77

Trapped
Outside working area
Wrong PIN code
No drive
Wheel motor
overloaded, right
Wheel motor
overloaded, left
Charging station
blocked
Stuck in charging
station
OM_1157863-26_HQ 310,315,EN_160229.indd 75
TROUBLESHOOTING
The robotic lawnmower has got
caught in something.
The robotic lawnmower is stuck
behind a number of obstacles.
The boundary wire connections to
the charging station are crossed.
The boundary wire is too close to the
edge of the working area.
The working area slopes too much
by the boundary loop.
The boundary wire is laid in the
wrong direction around an island.
Disturbances from metal objects
(fences, reinforcement steel) or
buried cables close by.
The robotic lawnmower finds it hard
to distinguish the signal from an
installation close by.
Wrong PIN code has been entered.
Five attempts are permitted, and
the keypad is then blocked for five
minutes.
The robotic lawnmower has got
caught in something.
The working area includes a steep
slope.
The guide wire is not laid at an angle
on a slope.
The robotic lawnmower has got
caught in something.
The contact between the charging
strips and contact strips may be poor
and the robotic lawnmower has made
a number of attempts to charge.
An object is obstructing the robotic
lawnmower.
There is an object in the way of the
robotic lawnmower preventing it from
leaving the charging station.
Free the robotic lawnmower and rectify the reason
for it becoming trapped.
Check if there are any obstacles which make it
hard for the robotic lawnmower to move on from
this location.
Check that the boundary wire is connected
correctly.
Check that the boundary wire has been laid
according to the instructions. See 3 Installation on
page 16.
Try moving the boundary wire.
Place the robotic lawnmower in the charging
station and generate a new loop signal. See 6.4
Security on page 46.
Enter the correct PIN code. Contact the local
dealer if you forget the PIN code.
Free the robotic lawnmower and rectify the reason
for the lack of drive. If it is due to wet grass, wait
until the lawn has dried before using the robotic
lawnmower.
Maximum guaranteed slope is 40%. Steeper
slopes should be isolated. See 3.4 Installation of
the boundary wire on page 22.
If the guide wire is laid on a slope, it must be laid at
an angle across the slope. See 3.6 Installation of
the guide wire on page 29.
Free the robotic lawnmower and rectify the reason
for the lack of drive. If it is due to wet grass, wait
until the lawn has dried before using the robotic
lawnmower.
Put the robotic lawnmower in the charging station
and check that the charging strips and contact
strips make good contact.
Remove the object.
English - 75
2016-02-29 10:52:39