Indicator Lamp In The Charging Station - Husqvarna AUTOMOWER 315 Operator's Manual

9.3 Indicator lamp in the charging station

For a fully functional installation, the indicator lamp in the charging station must emit a solid green light. If something
else appears, follow the troubleshooting guide below.
There is more troubleshooting help on www.automower.com. If you still need help with troubleshooting, please contact
the local dealer.
Light
Solid green light
Green flashing light
Blue flashing light
Red flashing light
Solid blue light
Solid red light
English - 78
OM_1157863-26_HQ 310,315,EN_160229.indd 78
TROUBLESHOOTING
Cause
Good signals
The signals are good and ECO mode
is activated.
The boundary loop is not connected
to the charging station
Break in the boundary loop
Interruption in the charging station's
antenna
Weak signal as the boundary wire is
too long. Max length is 800 metres.
Defective circuit board in the
charging station
Action
No action required
No action required. For more information on ECO
mode, see 6.8 Settings on page 59.
Check that the boundary wire connectors are
fitted properly to the charging station. See 3.5
Connecting the boundary wire on page 28.
Find out where the break is. Replace the
damaged section of the loop with a new loop
wire and splice using an original coupler.
Contact the local dealer.
No steps have to be taken if the robotic
lawnmower operates as expected.
Shorten the boundary wire by reducing the
working area or replacing islands with barriers
the robotic lawnmower can collide with.
Contact the local dealer.
2016-02-29 10:52:39