Measuring Cycles For Turning Machines; General Prerequisites; General Information; Overview Of Measuring Cycles - Siemens SINUMERIK 840D sl Programming Manual

Measuring Cycles for Turning Machines

6.1

General prerequisites

6.1.1

General information

The measuring cycles below are intended for use on turning machines.
To be able to run the measuring cycles described in this Chapter, the following programs
must be stored in the part program memory of the control.
Note
As of HMI sl software version 2.6
The GUD parameters are stored in the machine or setting data.
A correspondence/assignment list of the measuring cycle GUD parameters, GUD modules
and measuring programs used up to and including measuring cycles version 7.5, compared
to the machine and setting data as of measuring cycles version 2.6, is included in
appendices A1, A2 and A3.
6.1.2

Overview of measuring cycles

Cycle
CYCLE973
CYCLE974
CYCLE982
CYCLE994
6.1.3

Overview of the auxiliary programs required

Cycle
CYCLE102
CYCLE109
CYCLE110
CYCLE111
CYCLE114
CYCLE115
CYCLE117
CYCLE118
Measuring cycles
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
Function
Calibrate workpiece probe in the reference groove or on surface
1-point measurement with automatic tool offset or ZO determination
Calibrate tool probe, measure turning and milling tools
2-point measurement on diameter with automatic tool offset
Function
Measurement result display selection
Internal subroutine: Data transfer
Internal subroutine: Plausibility checks
Internal subroutine: Measuring functions
Internal subroutine (tool offset)
Internal subroutine (ZO compensation)
Internal subroutine: Measuring functions
Format real values: Log
6
261