Siemens SINUMERIK 840D sl Programming Manual page 422

Appendix
A.4 Overview of measuring cycle parameters
CYCLE961
_ID
REAL
_INCA
REAL
179.5
..179.5
degrees
_K
INT
_KNUM
INT
>=0
_MA
INT
_MD
INT
_MVAR INT
>0
_NMSP
INT
>0
_PRNUM
INT
>0
_RA
INT
_RF
REAL
_SETVAL
REAL
_SETV[0]
REAL
_SETV[1]
REAL
_SETV[2]
REAL
_SETV[3]
REAL
422
Workpiece measurements
---- Retraction in
infeed axis,
incremental
for overtravel of
corner if _ID=0
travels around
the corner
Angle from 1st edge to 2nd edge of the workpiece
(clockwise negative)
---- ----
Without/with automatic offset of the ZO memory
1...99: automatic offset in ZO G54...G57 G505...G599
1000: automatic offset in basic frame G500
1011...1026: automatic ZO correction in 1st to 16th basic frame
2000: automatic ZO in system frame
---- ----
---- ----
105 106
Number of measurements at the same location
(number of the data field assigned to the workpiece probe GUD6:_WP[_PRNUM-1])
---- ----
---- ----
---- ----
Distance between starting point and measuring point 2
(positive only)
Distance between starting point and measuring point 4
(positive only)
Distance between
measured and required
corner point in abscissa
only active if
_SETV[4]>1
Distance between
measured and required
corner point in ordinate
only active if
_SETV[4]>1
---- Retraction in
infeed axis,
incremental
for overtravel
of corner if
_ID=0 travels
around the
corner
---- ----
0: Without offset
---- ----
---- ----
Measuring variant
107 108
Probe number
---- ----
---- ----
---- ----
---- ----
---- ----
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
Infeed of positioning depth to
measuring depth (incremental)
----
----
----
----
117
----
----
----
Coordinates of point P1 in the active
workpiece coordinate system
(abscissa)
Coordinates of point P1 in the active
workpiece coordinate system
(ordinate)
Coordinates of point P2 in the active
workpiece coordinate system
(abscissa)
Coordinates of point P2 in the active
workpiece coordinate system
(ordinate)
Measuring cycles
----
----
----
----
118
----
----
----