General
1.12 Overview of measuring cycle functions for milling technology
Workpiece measurement: Outside rectangle
Result:
● Actual dimension: Rectangle length and width, rectangle center
● Deviation: Rectangle length and width, rectangle center
● Deviation: Tool offset of the zero offset
1.12.5
Measuring a workpiece at an angle
The following measuring variants are provided for the measurement of a hole, shaft, groove,
or web at an angle. They are executed by CYCLE979.
Three- or four-point measurement at an angle
Result:
● Actual dimension, deviation: Diameter, center point
● Deviation: Tool offset of the zero offset
50
Programming Manual, 03/2009 Edition, 6FC5398-4BP10-2BA0
Measuring cycles