Single Ip Phone Configuration; Quick Phone Configuration; Using The Keypad To Set Network Parameters - Huawei espace 7810 Administrator's Manual

Huawei IP Phone eSpace
7810&7820&7830&7850&7870&7803X
Administrator Guide
Configure and upgrade IP phones one by one if any of the following conditions is met:



This chapter describes how to configure a single IP phone.

2.1 Quick Phone Configuration

eSpace 7850 obtains an IP address by using Dynamic Host Configuration Protocol (DHCP) if
there is a DHCP server onsite. By default, eSpace 78XX series obtain IP addresses through
DHCP. When eSpace 7850 successfully obtains an IP address, press OK to view the IP
address.
If there is no DHCP server onsite, you need to use the keypad to set network parameters for
eSpace 7850.
The procedures for using the keypad to set the IP address, to configure the Session Initiation
Protocol (SIP) server, and to set the SIP account are complex. Therefore, you are advised to
set the IP address by using the keypad, and then access the web page to set other parameters.

2.1.1 Using the Keypad to Set Network Parameters

To use the keypad to set a static IP address, proceed as follows:
1.
2.
Issue 01 (2011-12-31)
2

Single IP Phone Configuration

There are only a few IP phones onsite.
The centralized upgrade environment is unavailable onsite.
Users require special services.
The methods for configuring eSpace 7870, 7850, 7830, 7820 and 7810 are similar. The configuration for
eSpace 7850 is the most complex. This document describes how to configure eSpace 7850. Only eSpace
7870, 7830, 7820 and 7810 configurations that are different from eSpace 7850 configurations are
described.
Press Menu on the IP phone to access the main menu.
For eSpace 7810, press MENU to access the main menu.
Press 3.
The Setting Type page is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Single IP Phone Configuration
4