Ip Phone Cannot Be Registered After The Ip Address Of The Ip Phone Changes; Ip Phone Cannot Provide Two-Stage Dialing When The Ip Phone Is Used With The Softco - Huawei eSpace 6805 Administrator's Manual

Hide thumbs Also See for eSpace 6805:
Table of Contents

Advertisement

eSpace 6805 IP Phone
Administrator Guide
5.2.7 IP Phone Cannot Be Registered After the IP Address of the
IP Phone Changes
If the IP address of the IP phone changes or a new IP address is obtained through DHCP, the
IP phone cannot be registered.
1.
2.
3.
Generally, you are advised to set the registration duration to the default value of 60 minutes.
The problem occurs when the IP phone is used with the SoftCo of V100R001C03 or earlier
one. When the IP phone is used with the SoftCo of later version of V100R001C03, such a
problem does not occur.
5.2.8 IP Phone Cannot Provide Two-Stage Dialing When the IP
Phone Is Used with the SoftCo
Problem
An IP phone cannot provide the two-stage dialing.
Cause
The SoftCo supports two dual-tone multi-frequency (DTMF) signal collection modes. That is,
in-audio and Info; therefore, the DTMF signal sending modes of the IP phone must be set to
in-audio and Info modes.
Solution
Check DTMF signal sending modes of the IP phone and ensure that in-audio and Info modes
are selected. For the eSpace 6805, access the Accounts > Account > Audio Settings page
and select in-audio and via SIP INFO in Send DTMF.
Issue 01 (2014-01-06)
Set up the packet capture environment, capture the SIP packets of the IP phone, and log
in to the SoftCo to view the SIPUE status of the IP phone.
If the SIPUE registers the original IP address, the SoftCo rejects the request when the
IP phone requests to be registered with the new IP address.
When the previous registration of the IP phone times out and the SIPUE status
becomes FAULT, the IP phone can be registered successfully again.
Before the timeout of registration, delete users from the SoftCo, and add users again.
Restart the IP phone. The IP phone can be registered successfully.
----End
After the eSpace 6805 IP phone receives Forbidden (403) messages, the IP phone sends the
re-registration request 30 minutes later if the setting is not changed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Troubleshooting
73

Advertisement

Table of Contents
loading

Table of Contents