Configuration And Loading Files; Configuring Network Parameters Using Buttons - Huawei eSpace 6805 Administrator's Manual

eSpace 6805 IP Phone
Administrator Guide

3.1 Configuring Network Parameters Using Buttons

If the DHCP server exists on site, an eSpace 6805 IP phone can obtain an IP address through
DHCP. By default, eSpace-series IP phones obtain IP addresses through DHCP. If the eSpace
6805 IP phone obtains an IP address successfully, the IP address is displayed. You can use the
displayed IP address to log in to the Web page of the IP phone to set the other parameters.
If the DHCP server does not exist on site, you must set the network parameters for the eSpace
6805 IP phone separately. The procedures for setting the IP address, SIP server, and SIP
account through the keypad for eSpace 6805 are complicated. Therefore, it is recommended
that you set the IP address through the keypad, and log in to the Web page to set the other
parameters.
To set a static IP address through the keyboard in the English system, proceed as follows:
1.
2.
3.
4.
5.
6.
7.
8.
----End
Issue 01 (2014-01-06)
3

Configuration and Loading Files

Press the MENU key on eSpace 6870 to enter the configuration page.
Press the Up or Down key to select Network, and press the MENU key.
Press the Up or Down key to select IP Setting, and press the MENU key.
Press the Up or Down key to select Static IP, and press the MENU key.
Press the Up or Down key to select IP, and press the MENU key. Press the BackSpace
key to delete an IP address, enter the required IP address, and press the OK key.
Repeat step 5 to set Netmask and Gateway.
Press the left key or Back soft key to return to the Menu page.
Press the Up or Down key to select Reboot, and press the MENU key to make the
configurations take effect.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuration and Loading Files
5