Preset Speed Operation Mode - Toshiba H9 ASD Installation And Operation Manual

F552
Speed 13 Operation Time
Program Pattern Run Operation Time
This parameter sets the run-time for Preset Speed 13.
This time is effective when used with Group Speeds and non-Group Speeds.
If the Auto-Restart function is activated, the search time required for the Auto-
Restart function will be subtracted from the Operation Time setting; resulting
in a shorter run time.
Speed 14 Operation Time
Program Pattern Run Operation Time
This parameter sets the run-time for Preset Speed 14.
This time is effective when used with Group Speeds and non-Group Speeds.
If the Auto-Restart function is activated, the search time required for the Auto-
Restart function will be subtracted from the Operation Time setting; resulting
in a shorter run time.
Speed 15 Operation Time
Program Pattern Run Operation Time
This parameter sets the run-time for Preset Speed 15.
This time is effective when used with Group Speeds and non-Group Speeds.
If the Auto-Restart function is activated, the search time required for the Auto-
Restart function will be subtracted from the Operation Time setting; resulting
in a shorter run time.

Preset Speed Operation Mode

Program Pattern Run Operation Mode
This parameter is used to set the Preset Speed operating mode.
Select Disabled at this parameter to use the speed command only for Preset
Speed operation.
Select Enabled at this parameter to apply the control settings of
the associated Preset Speed while operating in the Preset Speed mode.
Settings:
0 — Disabled (Preset Speed Only)
1 — Enabled (Full Preset Speed Mode)
H9 ASD Installation and Operation Manual
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Direct Access Number — F552
Parameter Type — Numerical
Factory Default — 5.0
Changeable During Run — Yes
Minimum — 0.1
Maximum — 6000.0
Units — F520
Direct Access Number — F553
Parameter Type — Numerical
Factory Default — 5.0
Changeable During Run — Yes
Minimum — 0.1
Maximum — 6000.0
Units — F520
Direct Access Number — F554
Parameter Type — Numerical
Factory Default — 5.0
Changeable During Run — Yes
Minimum — 0.1
Maximum — 6000.0
Units — F520
Direct Access Number — F560
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — No
F561 – F575 to
F560
Setting
Setting
Setting
179