Over-Torque Detection Level; Over-Torque Detection Time; Cooling Fan Control; Cumulative Operation Time Alarm - Toshiba H9 ASD Installation And Operation Manual

F616
Over-Torque Detection Level (Positive Torque)
Program Protection Over-Torque Parameters
This parameter sets the torque threshold level that is used as a setpoint for over-
torque tripping during positive torque. This setting is a percentage of the
maximum rated torque of the drive.
This function is enabled at F615.
Over-Torque Detection Level (Negative Torque)
Program Protection Over-Torque Parameters
This parameter sets the torque threshold level that is used as a setpoint for over-
torque tripping during negative torque (regen). This setting is a percentage of
the maximum rated torque of the drive.
This function is enabled at F615.

Over-Torque Detection Time

Program Protection Over-Torque Parameters
This parameter sets the amount of time that the over-torque condition may
exceed the tripping threshold level set at
This function is enabled at F615.
Over-Torque Detection Hysteresis
Program Protection Over-Torque Parameters
During a momentary over-torque condition, this parameter provides a torque
threshold level to which the over-torque condition must return within the time
setting of F618 or an Over-Torque Trip will be incurred.

Cooling Fan Control

Program Protection Special Protection Parameters
This parameter sets the cooling fan run-time command.
Settings:
0 — Automatic
1 — Always On

Cumulative Operation Time Alarm

Program Protection Special Protection Parameters
This parameter sets a run-time value that, once exceeded, closes a discrete
output contact. The output signal may be used to control external equipment or
used to engage a brake.
Associate the Total-Operation-Hours Alarm setting of
discrete output contactor.
Note: The time displayed is 1/10th of the actual time (0.1 hr. = 1.0 hr.).
186
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
F616 and F617 before a trip occurs.
Table 8 on pg. 239
Direct Access Number — F616
Parameter Type — Numerical
Factory Default — 200.00
Changeable During Run — No
Minimum — 0.00
Maximum — 250.00
Units — %
Direct Access Number — F617
Parameter Type — Numerical
Factory Default — 200.00
Changeable During Run — No
Minimum — 0.00
Maximum — 250.00
Units — %
Direct Access Number — F618
Parameter Type — Numerical
Factory Default — 0.50
Changeable During Run — No
Minimum — 0.00
Maximum — 10.0
Units — Seconds
Direct Access Number — F619
Parameter Type — Numerical
Factory Default — 10.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 100.00
Units — %
Direct Access Number — F620
Parameter Type — Selection List
Factory Default — Automatic
Changeable During Run — Yes
Direct Access Number — F621
Parameter Type — Numerical
Factory Default — 610.0
Changeable During Run — Yes
Minimum — 0.0
Maximum — 999.9
to a
Units — Hours (X 10)
H9 ASD Installation and Operation Manual
F621