Terminal Board; Default Setting - Toshiba H9 ASD Installation And Operation Manual

J100
1 to 2 = Sink (*)
2 to 3 = Source
J101
(24V)
1 to 2 = Sys. Supplied (*)
SW301
2 to 3 = Ext. Supplied
SW301
V/I Switch (I*)
TB1
TB2
TB3
TB4
*

= Default Setting

24
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Figure 8. FLA, FLB, and FLC Switching Contacts Shown in the Normal Operating Condition.
Note: The relay is shown in the normal operating condition. During
a faulted condition the relay connection is FLC-to-FLA.
Figure 9. Terminal Board.
CAUTION
See Typical Connection Diagram on pg. 26
See the section titled Terminal Descriptions on pg. 22
See the section titled Cable/Terminal/Torque Specifications on pg. 264
cable/terminal sizes and torque specifications when making Terminal Board connections.
Sink Source
Ensure that the ground screw is securely in
place to prevent arcing, intermittent
operation, or system failure.
SW200
Half / Full Duplex (*) Switch
S4
RS485 4-Wire Communication
for more information on the Terminal
for terminal descriptions.
for information on the proper
H9 ASD Installation and Operation Manual