Table of Contents
Advertisement
10. If automatic collection was selected, an
initialization warning will appear to notify you
that the operating system on the application
server that the array automatically connects to
can affect how the array is configured during the
initialization process. If the array is being
installed in an environment other than Windows,
please refer to the array user manual before
continuing. Otherwise, click OK to continue.
11. At the Set Network Parameters window, type in
the network addressing information for each
controller that will be used on the array. The IP
Address for each controller should be unique
and should be reserved in any DHCP server
before configuring. After typing in the network
information for the array, click Next to continue.
12. After you type in the network information for the
array, a confirmation window will appear. Verify
that the information entered was correct, and
then click Set to continue.
If the information is not correct, click Back and
type the information again before continuing.
13. At the Set Host Connection Port Parameters
window, review the port parameters for the
array. If any parameters need to be changed,
highlight the port to be changed and click Edit
on the right of the port list. If an iSCSI Naming
Service server is to be used, configure the iSNS
Server settings by clicking the Set iSNS Server
button at the left side of the window. After all
ports are configured correctly, click Next to
continue.
NEC D3-10i Quick Start Guide
37
Advertisement
Table of Contents
