NEC D3-10i Quick Start Manual page 42

20. After setting the logical disk name and platform
type, you can configure the initiator node that
the logical disk will be bound to. Select the
initiator from the Assignable Initiators section,
and then click Add to assign an iSCSI Initiator to
the specified Destination LD Set or select the
Type In/Edit button to manually enter an
Initiator's information.
Once an initiator has been selected for the
destination logical disk set, click Next to
continue.
21. The Select LD Binding Parameters window
allows you to create and bind logical disks to
application servers.
The following options are available when binding
logical disks from the wizard:
Bind/Select – This takes you to the Bind
Pool and Bind Select window which allows
you to configure and select a pool to be
bound to logical disks.
LD Capacity – Set the capacity of the logical
disks.
Number of LDs – Set the number of logical
disks to create.
LD Name Prefix – Add a prefix name to the
logical disk.
Quick Format – Perform a quick format of
any logical disks created.
GPT Disk Type – Enable GPT type if a
volume is larger than 2 TB.
Create Hot Spare – Assign a physical disk
as a hot spare drive for the logical disk.
(Recommended)
When all settings are correct, click Next to
continue.
Note: If you change the Number of LDs, the LD Capacity needs to be manually changed.
NEC D3-10i Quick Start Guide 40