NEC D3-10i Quick Start Manual page 65

8. After the installation process has copied
all PathManager files and configured the
PathManager installation, the
InstallShield Wizard Completed window
will appear. Click Finish to close the
installation wizard.
9. After completing the installation
process, the server will need to be
restarted. Click Yes to restart the
server immediately or click No to
perform any other necessary tasks
before restarting the server.
10. After the server restarts, the storage
array can be reconnected to the server
and any additional PathManager
configuration activities can be
performed on the server if needed.
At this point, the PathManager software installation is complete and PathManager should recognize any
disk subsystems and paths to the array needed to operate normally.
To learn how to monitor PathManager functionality or perform any additional multipath configuration
tasks, please refer to the Storage PathManager documentation contained on the Storage Manager CD.
© 2009 NEC Corporation of America. NEC is a registered trademark of NEC Corporation. All Rights Reserved.
Other product or service marks mentioned herein are the trademarks of their respective owners. PN# 456-01815-001
NEC D3-10i Quick Start Guide 63