ABB 83342-500 User Manual page 37

Operating Instructions
ABB-Welcome
4. Select a Telephone Gateway device in the list, and input the password. Default password: 1234.
Fig. 26
5. If the password is correct, it will display as follows:
Fig. 27
No. Function
1 Click "Edit" to change the passwords. (4 digits)
2 Installer can select "Enable" or "Disable" for Direct-accept from the list.
3 Installer can Enable/Disable "Call Divert for All Indoor Stations."
4 This Admin Password is used when user logs in at TGW.
5 Installer can edit Default Phone Number directly with maximum 16 digits.
6 Installer can Enable/Disable "Indoor Station PIN Active for all Indoor Stations ."
7 All Indoor Station numbers are listed from 1 to 250.
8 Installer can select "Yes" or "No" from "Existed" according to actual installation.
a.
b.
9 Installer can select "Enable" or "Disable" from "Indoor Station PIN Active."
10 Installer can select "Default" or "Primary" or "Secondary" from "Call Divert Number Active ."
11 Installer can edit Primary and Secondary Phone Number, with maximum phone number is 16 digits .
12 Installer can edit Indoor Station PIN. (4 digits)
13 Click "Export", all current parameters of the telephone gateway are exported to *.txt. If the installer did
modification but didn't click "Send", then click "Export", the original parameters are exp orted.
14 After imported, installer must click "Send" to send these parameters to telephone gateway. (This is only for
replacement in field.)
If "Yes" is selected, all parameters on its right can be edited.
If "No" is selected, all parameters on its right is deleted, which means this Indoor Station is deleted
from the Indoor Station address.
— 36 —