Table of Contents
Advertisement
Section 700 - Operation
To assign Flexible Feature Codes to an FF key:
1. Lift the handset or press the ON/OFF key.
2. Press the PROG key.
3. Press the FF key to be programmed.
4. Enter the code to be programmed. (See Table 13 on page
154.)
5. Press the HOLD key.
6. Repeat steps 2-5 to program additional keys.
7. Replace the handset or press the ON/OFF key.
To erase a code stored on an FF key:
Note:
You cannot use the following procedure to clear FF keys that have been assigned as CO lines.
CO line keys can only be cleared through system programming.
1. Lift the handset or press the ON/OFF key.
2. Press the PROG key.
3. Press the FF key that was programmed.
4. Press the HOLD key.
To check a programmed FF key (Display Phone Only):
1. Lift the handset or press the ON/OFF key.
2. Press the CONF key.
3. Press the FF key to be checked.
4. Replace the handset or press the ON/OFF key.
Hardware Requirements
•
N/A
Related Programming
•
FF1-2: Dial Plan
•
FF3: Extension Numbers
•
FF4: FF Key Assignment
576-13-700
Action
Action
Action
DBS 576 (USA), Revised 6/11/98
Chapter 5. Key Telephone Features
Result
Intercom dial tone
F displays
Enter Function# displays
Programmed code displays
Programmed function name displays
Result
Intercom dial tone
Programmed code displays
Cleared Function displays
Result
Intercom dial tone
C displays
Programmed data displays
153
Advertisement
Table of Contents
