Table of Contents
Advertisement
Chapter 6. DSLT Features
Flash
CPC-96, CPC-288, and CPC-576 Version 1.0
Description
You can send a flash signal on your telephone to release an outside line and then either automatically
reseize the same outside line or switch to extension dial tone status by pressing the FLASH key.
Trunk programming determines whether your phone reseizes the outside line or switches to extension
dial tone status.
Hardware Requirements
•
N/A
Related Programming
•
FF1-1: Flash Timer
•
FF2: Flash Pattern
•
FF2: Flash Key Operation
•
FF3: Flash on PROG (Recall)
Considerations
•
N/A
Hot Line
CPC-96, CPC-288, and CPC-576 Version 1.0
Description
Hot Line enables you to immediately connect to another pre-assigned extension or speed dial number
simply by lifting the handset. You do not have to dial any digits.
Operation
To immediately connect to a pre-assigned extension or speed dial number:
1. Lift the handset or press the ON/OFF key.
Hardware Requirements
•
N/A
Related Programming
•
FF5-5: Hot Line
230
Action
DBS 576 (USA), Revised 6/11/98
Section 700 - Operation
Result
Automatically connected to pre-assigned
extension or speed dial number
576-13-700
Advertisement
Table of Contents
