Panasonic 524X07801B Technical Manual page 154

Chapter 5. Key Telephone Features
Considerations
• If a new code is programmed into a key, the previously programmed code is erased.
• FF keys assigned as CO lines must be cleared using system programming before new FF
assignments can be made.
• The System can be programmed so that MCO 1 Trunk Access calls automatically use Automatic
Route Selection (ARS).
• The ANSWER key functions as listed in the table below.
Status
Idle
Off-Hook
NOTE: When the extension has 1 non-appearing CO on hold and 1 non-appearing CO at talk, ANSWER key oper-
ation is ignored and you can't put the 2nd non-appearing CO on hold.
• The RELEASE key functions as listed in the table below.
Status
Idle
Monitor ON (speaker)
or Headset Mode
Handset Off-Hook
•
Table 13. Feature access codes for FF key assignments
Feature Description
CO Trunk Key
MCO Key
Virtual Port Key
BLF/DSS Outgoing
BLF/DSS Immediate Ring
BLF Delayed Ring
154
Condition
No incoming ring
Incoming ring
Off-hook signaling
No off-hook signaling
Condition
--
Several held calls
No held calls
Several held calls
No held calls
Fixed Feature Code
+ (additional digits to program into
key)
# + (Trunk 1-576)
1 + (Auto-Select Pattern 1-5;
MCO-Incoming Trk Grp 00-99)
9 + (Virtual Port 001-576)
9 + (Extension 0-9999)
81 + (Extension 0-9999)
82 + (Extension 0-9999)
DBS 576 (USA), Revised 6/11/98
Operation when ANSWER key is pressed
Ignore.
Monitor ON (speaker) - Auto Answer for incoming ring.
Answer for off-hook signaling. Current conversation will be
put on hold automatically.
Ignore.
Operation when RELEASE key is pressed
Ignore.
Latest held call will be transferred; phone returns to idle sta-
tus (Monitor OFF).
Current call (talk) will be released; phone returns to idle sta-
tus (Monitor OFF).
Latest held call will be transferred; phone gets internal dial
tone.
Current call (talk) will be released; phone gets internal dial
tone.
Section 700 - Operation
Default Flexible Feature Code
(if not listed, must use Fixed Feature
Code)
576-13-700