Customize The Eeprom On The Main Pcb (Function Code 74); Initialize The Eeprom On The Main Pcb (Function Code 01); Load Local Programs; Restore Machine Information (Function Code 46) - Brother DCPJ525W Service Manual

2.2

Customize the EEPROM on the main PCB (Function code 74)

Refer to Chapter 5, Section
Note: Once this procedure is carried out, it is necessary to write the corresponding language
data, so be sure to write local programs, referring to
2.3

Initialize the EEPROM on the main PCB (Function code 01)

Refer to Chapter 5, Section
2.4

Load local programs

Note: This procedure is not required when no EEPROM customizing has been performed with
Function code 74 in
Reload local program, referring to
(Updating existing
2.5

Restore machine information (Function code 46)

Restore the machine information and user setting information that have been backed up in an
external memory, referring to
If the machine information is successfully restored, it is not necessary to perform operations given in
Sections 2.9 to
If the machine has failed to back up the machine information into an external memory at the
start of repair, replace the ink absorber box and flushing box, and then reset each of the purge
and flushing counts with the following procedure.
(1) Switch the machine to the maintenance mode. (Refer to
(2) Press the 8 and 0 keys in this order.
(3) Press the Black Start (Mono Start) key several times until the purge (or flushing) count
appears on the LCD.
(4) Press the 2, 7, 8 and 3 keys in this order to reset the purge (or flushing) count.
(5) Press the Stop/Exit key to return to the initial stage of the maintenance mode.
2.6

Restore head calibration data (Function code 68)

Restore head calibration data that has been backed up, referring to
If restoring head calibration data ends successfully, it is not necessary to perform operations
given in Section
2.7

Check the sensor operation (Function code 32)

Refer to Chapter 5, Section
2.8

Specify the CIS type (Function code 59)

Refer to Chapter 5, Section
1.4.26.
1.4.1.
Section 2.2 in this chapter.
Section 2.1.2 "If the main PCB loaded with programs is used
programs)."
Chapter 5, Section
2.13 and 2.17.
2.14.
1.4.11.
1.4.18.
Section 2.4
1.4.12.
Chapter
4-22
below.
5.)
Chapter 5, Section 1.4.23.
Confidential