Possible Optipoint Adapter Configurations - Siemens HiPath 5000 Service Manual

wclient.fm
Workpoint Clients
optiPoint 500
10.2.3.6

Possible optiPoint Adapter Configurations

Adapter categories
Each U port in the system provides two B channels. This means that you can connect two
P0/E
telephones, each with a separate phone number, to one U
Category 1 optiPoint 500 adapters
The following adapters each require a B channel and, therefore, can only be used once on a
host terminal (host terminal requires the second B channel of the U
optiPoint Analog Adapter
●
optiPoint ISDN Adapter
●
optiPoint Phone Adapter
●
If one of these adapters is used in the optiPoint 500 advance, only a category 2 adapter can be
operated in the second slot.
Category 2 optiPoint 500 adapters
The following adapters can be used on the host and client telephones. This is also true if a cat-
egory 1 optiPoint 500 adapter is already connected.
optiPoint Acoustic Adapter
●
optiPoint Recorder Adapter
●
Configuration restrictions
The voltage feed test can be used to check whether a
>
essary for an adapter configuration. To avoid any doubts, the test should always be
implemented when installing large configurations.
Number of usable adapters and add-on devices
Section 10.2.5 shows the maximum number of adapters and add-on devices that can be con-
nected to HiPath 3000/5000. The limits also include the client telephones connected over opti-
Point phone adapters and the analog telephones connected over optiPoint analog adapters.
10-30
P0/E
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
port.
port).
P0/E
local power supply
P31003-H3560-S403-54-7620, 09/05
is also nec-