Siemens HiPath 5000 Service Manual page 598

inst_h3.fm
Installing HiPath 3000
Installing HiPath 3750, HiPath 3700
If
Slot with any Route 16 TW to the MDFU or MDFU-E via SU Xx8 using a CABLU.
other peripheral Part numbers for CABLUs with 16-TW jumper strips:
board
●
●
Assignment 16 TWs are routed to (and manually laid at) the MDFU or MDFU-E via
with SU X6 (backplane) using an open-end cable.
REAL Part numbers for open-end cable:
●
●
●
1 A CABLU with 16 TW is also sufficient for these boards. A CABLU with 24 TW is recommended to simplify station config-
uration expansion (for example, by replacing the SLMO8 by an SLMO24).
For U.S. Only: CABLUs for the slots containing peripheral boards (Figure 4-88)
If
Slot with 24-port Route 16 TW to the main distribution frame via SU Xx8 and 8 TW via
peripheral board SU Xx9, using standard CABLU S30267-Z365-A30 (SU connectors are la-
beled "8" and "9"). Both cables are connected to the same 50-pin Champ
jack.
Slot with 16-port Route 16 TW to the main distribution frame via SU Xx8 using standard CA-
peripheral board BLU S30267-Z365-A30.
Slot with TMST1 T1 connections (see Section 3.3.41, "TMST1 (for U.S. only)") are not set up
via the main distribution frame.
An adapter (1 SU connector - 8-pin MW8 (RJ48C) jack, Figure 4-68) is con-
nected directly to the SU Xx9 backplane connector. You can use a special
cable to create a direct connection to the CSU or networked system.
4-120
S30269-Z100-A11: 3 m in length, short stripped length for MDFU-E
slots 11-21 (see Figure 4-72)
S30269-Z100-A21: 3 m in length, long stripped length for MDFU-E
slots 1-10 (see Figure 4-72)
S30267-Z192-A60: 6 m in length
S30267-Z192-A100: 10 m in length
S30267-Z192-A200: 20 m in length
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
Then
Then
P31003-H3560-S403-54-7620, 09/05