Installing The Tapi Service Provider - Siemens HiPath 5000 Service Manual

6.6.6

Installing the TAPI Service Provider

This section describes the separate installation of the TAPI Service Provider.
The numbers for stations, trunks, and groups can be set up directly after installation of the TAPI
Service Provider.
1. Insert the TAPI Service Provider installation CD and run Setup.
2. Confirm the welcome dialog that appears with Next.
3. The Setup Type dialog appears. Mark HiPath 3000/5000 V6.0 and confirm your selection
with Next.
The appropriate installation components are automatically preselected when you select
the setup type. The following are installed for HiPath 3000/5000 V6.0:
TAPI Service Provider TSP
●
CSTA Message Dispatcher CMD
●
CSTA Service Provider CSP
●
Central Configuration Manager Client CCMC
●
4. The system starts to install the selected components.
When a component is successfully installed, the associated configuration dialog opens.
You can set the required parameters here or postpone configuration until a later time. For
further information, please refer to the online help for the TAPI Service Provider.
5. When all selected components are installed, a dialog appears in which you can terminate
the installation with Finish
6. Confirm the subsequent system message to enable the ACD service if the Call Center ap-
plication HPCO is connected.
The TAPI service provider is now installed. For further information, please refer to the online
help for the TAPI Service Provider.
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
HiPath 5000 Startup and Administration
start_h5.fm
HiPath 5000
6-35