Result
The connection between the communication partners has been created as an integrated
connection and is automatically assigned a name.
You can see the connection in the "Connections" editor and change the assigned name, if
necessary.
Note
Access point for both HMI connections must be "S7ONLINE"
Depending on the order in which you configure the HMI connections, an incorrect access
point may be entered (e.g. "S7ONLINE1" instead of "S7ONLINE").
In this case, change the name of the access point to "S7ONLINE" in the "Connections"
editor.
Figure 5-3
SINUMERIK Integrate Create MyHMI / WinCC V13 SP1
Configuration Manual, 11/2014
Setting of the access point in the "Connections" editor
Configuring connections
5.2 Configure an integrated connection
65