Mitsubishi Electric FX3G SERIES Programming Manual page 118

FX /FX /FX Series Programmable Controllers
3G 3U 3UC
Programming Manual - Basic & Applied Instruction Edition
• Write the following program to "reset only the current value of a high-speed counter (and does not turn OFF the
contact)".
1) Program example
*
X010
* When the driving contact is the continuous execution type, the current value of the counter is reset to "0"
at each scan while X010 remains ON.
2) Timing chart
X000
Current
value of C235
X010
Because X010 turns ON,
"FNC12 DMOV" is executed.
The current value of C235 is
reset to "0".
• Write the following program to "turn OFF the contact and reset the current value of a high-speed counter".
1) Program example
X010 *
* When the driving contact is the continuous execution type, the current value of the counter is reset to "0"
and the counter reset status is cleared at each scan while X010 remains ON.
2) Timing chart
X000
Current
value of C235
X010
RST
C235
116
FNC 12
K0 C235
DMOV
3
2
1 1
RST
M8001
RST
RUN Monitor
(normally OFF)
3
2
1 1
Counter reset instruction is
Counter is reset
deactivated
(part A in above
(part B in above program).
program).
4.7 High-Speed Counter [C] (FX3U/FX3UC PLC)
The current value of C235 is cleared (to "0").
4
3
2
Because the driving contact is the
pulse execution type, C235 executes
counting normally after that.
- - - - - A
C235
- - - - - B
C235
4
3
2
4 Devices in Detail
Because the reset instruction
is deactivated, C235 executes
counting.