Initializing A Volume From The Archive Volume Aspect - ABB 800xA User Manual

Maintaining Archive Media
set to Advance When Full or Wrap When Full. For manual archives, the volume
must be manually initialized.
For MO drives, before the archive volume is initialized, make sure the media has
been formatted as described in
Initialization of archive volumes may be done using the archive device aspect for the
archive device whose volume needs to be initialized, or the archive volume aspect
may be used.
To initialize a volume:
1.
2.
3.
Figure 68. Initializing a Volume From the Archive Volume Aspect
114
Install the archive media in the disk drive.
Navigate to and select either the archive device aspect whose volume is being
initialized, or select the applicable archive volume aspect.
If the archive volume aspect is being used, invoke the Initialize command from
the Action button or context menu as shown in
5 which pertain only when using the archive device aspect. Resume the
procedure at Step 6.
Section 7 Configuring Archives
Removing/Replacing Platters
Figure
on page 110 .
68, then skip steps 4 and
2PAA107563-600 B