Table of Contents
Advertisement
Activate/Deactivate an Archive Device
ISO Image creates an ISO image file for the currently active volume when the
volume becomes full. The ISO Image file can then be copied to a ROM media for
permanent storage.
Copy Files creates a shadow copy rather than an ISO Image file.
BOTH creates both an ISO image and a shadow copy.
Disk Utilization Alarms
The two check boxes near the bottom of the Config view are used to choose whether
or not to generate an alarm when the archive media (or backup media) exceed a
specified disk usage limit. Specify the limit as a percentage of disk usage, or as
megabytes used. Choose to generate alarms by checking the respective check boxes.
The alarms are recorded in the 800xA System Message Services.
Activate/Deactivate an Archive Device
An archive device must be active in order to archive data to, or restore data from the
device. When the archive media is MO Drive, the corresponding archive device
must be deactivated to remove and replace a platter. To activate/deactivate an
archive device, go to the Archive Device aspect main view, click Actions and choose
Activate or Deactivate.
Configuring Archive Groups
Archive groups support scheduled or manual archiving for a group of logs as a
single unit. This is done through an archive group aspect. One or more archive
groups may be added to this aspect, and each group specifies a set of items (logs
and/or aspect objects) to be archived as a unit.
To configure scheduled archive operations, configure a job in the Scheduling
structure. The association between the schedule and a specific archive group is
made via an Archive Action aspect which must be added to the job in the
Scheduling structure.
This section describes how to create an archive group and configure a job to
schedule archive actions. Start with
90
Section 7 Configuring Archives
Adding an Archive Group
on page 90.
2PAA107563-600 B
Hide quick links:
Advertisement
Table of Contents
