Mitsubishi Electric AE-200A Instruction Book page 106

For ② and ⑤ , check the connection relationships between the outdoor and indoor units from [Initial Settings]
> [System View] on the AE-200's LCD.
Check that the outdoor unit model name and indoor unit model name are entered in ③ and ⑦ , and check
that each combination of the outdoor unit and indoor unit is correct.
Check that ⑤ and ⑥ are entered correctly using the addresses and types set in section 6-6-1 "Group
settings".
Check that ② and ④ are entered correctly using the outdoor unit addresses and standby electric power set
in section 6-7-2 "Outdoor unit settings".
If there are sub-units (OS1, OS2) connected to an outdoor unit, the standby electric power should be the total
of the main unit and sub-units.
Check that ⑤ and ⑧ are entered correctly using the cooling capacity, fan power consumption and standby
electric power set for each indoor unit address in section 6-7-3 "Indoor unit settings".
Check that ⑤ and ⑨ are entered correctly using the indoor unit addresses and indoor unit electricity meters
set in section 6-7-4 "Measurement settings".
Check that ② and ⑩ are entered correctly using the outdoor unit addresses and outdoor unit electricity
meters set in section 6-7-4 "Measurement settings".
Note
• For the outdoor unit (address: 51) and outdoor sub-unit (address: 52), the output unit address will be 51/52
and the output standby electric power will be 0.14.
• For a LOSSNAY unit, [-] will be displayed for the outdoor unit address, standby electric power and indoor
unit cooling capacity.
• For a DIDO controller, AI controller or PI controller, [-] will be displayed for the outdoor unit address and
standby electric power, the indoor unit cooling capacity, and the fan power consumption and standby
electric power.
• The charge calculation results will be output for each energy management block.
• A-control units will not be displayed on the "System View" screen. Check their connection status
separately.
WT07442X02
106