Initial Settings; General Descriptions; Flow Of The Initial Settings And Billing Function Trial Run - Mitsubishi Electric AE-200A Instruction Book

6. Initial settings

6-1. General descriptions

Before using an apportioned electricity billing function (AE-200 Apportion), initial settings and trial run must
be completed beforehand by authorized personnel on site. Please receive an explanation from your dealer or
contractor on how to use the function.
* For dealers and contractors
Install the software (tool), make initial settings, and perform trial runs according to the procedures in the order of sections
5, 6, and 7 in this manual. Provide sufficient explanation about an apportioned electricity billing function to the customer,
referring to section 2 (2-6).
Before making initial settings for an apportioned electricity billing function, check that the other initial settings and
trial runs have been completed on the AE-200, Initial Setting Tool, or the Web Browser for Initial Settings.
Note
• Make sure that the software versions of the AE-200/AE-50/EW-50 are the same (Ver. 7.23 or later).
(For how to update the software, refer to the AE-200/AE-50/EW-50 Installation Manual.)

6-1-1. Flow of the initial settings and billing function trial run

Preparation
Normal initial settings

Initial settings

Billing
function
Checking the initial settings (before billing function trial run)
trial run
1st run check (after air conditioning unit
continuous operation)
2nd run check (at least 10 days after 1st
run)
3rd run check (at least 1 month after 2nd
run) *5
*1 Complete settings such as unit settings, network settings, license registration, group settings, block settings and measurement settings.
*2 Refer to section 6-1-2 "Required settings to use an apportioned electricity billing function" for items to be set on the Initial Setting Tool
and Charge Calculation Tool.
*3 If any setting changes are needed during a billing function trial run, make the settings on the Initial Setting Tool.
*4 Run each indoor unit continuously for at least 2 hours.
*5 Check at least 1 month after the 2nd billing function trial run on the day after the closing date.
WT07442X02
*1 and trial run for all AE-200 systems
AE-200 settings
Settings on the Initial Setting Tool
Settings on the Charge Calculation Tool
Air conditioning unit continuous
operation *4
Trial run period (at least 1 day)
Charge calculation (Specified date
calculation)
Air conditioning unit normal operation
Trial run period (at least 10 days)
Charge calculation (Specified date
calculation)
Air conditioning unit normal operation
Trial run period (at least 1 month)
Charge calculation (Specified date
calculation)
*2
*2
*3
*3
*3
52
<Billing function trial run example>
to Apr. 1
Billing function trial
Apr. 2
run period
1st run check
Apr. 3
(Specified date calculation (Apr. 2))
Billing function trial
Apr. 4 to 13
run period
2nd run check
Apr. 14
(Specified date calculation (Apr. 4 to 13))
Billing function trial
Apr. 15 to May 20
run period
3rd run check
May. 21
(Specified date calculation (Apr. 15 to May 20))