Mitsubishi Electric AE-200A Instruction Book page 73

9. In "Brightness sensor display", make the Show/Hide setting for the brightness/darkness status that is
detected by the built-in brightness sensor on the ME remote controller (North America: PAR-U01MEDU,
Other countries: PAR-U02MEDA).
Select [Hide] not to display the brightness/darkness icons on the Condition List screen.
Select [Show bright icon] to display the brightness icon when the brightness level in the room reaches the
predetermined brightness level.
Select [Show dark icon] to display the darkness icon when the darkness level in the room reaches the
predetermined darkness level.
Select [Show both icons] to display the brightness or darkness icon according to the brightness/darkness
level of the room.
10. In "Humidity sensor display", make the Show/Hide setting for the humidity reading of the built-in humidity
sensor on the ME remote controller (North America: PAR-U01MEDU, Other countries: PAR-U02MEDA).
Select [ON] to display the humidity reading on the Condition List screen.
[6] CSV file format settings (separator character and decimal point character)
Procedures
1. Set the format of the AE-200 CSV file (apportioned results, charges calculation results from the Charge
Calculation Tool).
Important
• This setting must be the same with the "Decimal point character for CSV file" and "Separator character for
CSV file" settings on the [Advanced Settings] screen on the Charge Calculation Tool. If the settings are not
the same, an error message "The CSV file format is not appropriate. Check the directory from which the
CSV file is acquired." will appear.
• When multiple AE-200 units are connected, make the same settings for all of them.
[7] Saving the settings
Click [Save] after setting [1] to [6] above.
WT07442X02
Brightness icon
(Yellow)
73
Darkness icon
(Gray)