Panel-Mounting - ABB SM500F User Manual

SM500F
Field mountable paperless recorder

2.2.1 Panel-Mounting

Note. If removal of knockouts is required, refer to Section 2.3.1, page 15.
Referring to Fig. 2.4, secure the recorder in a panel as follows:
a
Cut the correct sized hole in the panel – see Fig. 2.3, page 10.
b
Insert the recorder into the panel cut-out.
c
Screw one clamping screw into the left-hand bracket until 10 to 15mm of the thread protrudes from
the other side of the bracket and position one clamp over the end of the thread.
d
Holding the assembly together, position the bracket into the left-hand recess on the rear of the
recorder case and secure with the bracket securing screw. Ensure that the plastic washer remains in
the position fitted.
Repeat instructions
e
Tighten the clamping screws evenly and securely by hand.
Note. This is critical in order to ensure proper compression of the panel seal and achieve the
IP66/NEMA 4X hosedown rating.
Fig. 2.4 Installing the recorder – Panel-Mounting
IM/SM500F Rev. Z
3 4
and for the right-hand panel clamp assembly.
2 Installation
11