I/O Module Configuration; Analog Inputs - ABB SM500F User Manual

SM500F
Field mountable paperless recorder

7.10 I/O Module Configuration

Fig. 7.17 I/O Module Configuration
Note. The recorder detects the type of module fitted in each position automatically.

7.10.1 Analog Inputs

IM/SM500F Rev. Z
Set the mains rejection frequency used to filter electrical noise induced on
the signal lines by power supply cables.
Set to 'On' to enable input adjustment from Logging menu – see page 50.
Note. The following parameter is displayed only if recording is enabled
during configuration, i.e. the 'Disable recording in configuration' check
box is ticked on entry to the Configuration level – see Fig. 7.1,
not
page 66.
Input Adjustment
Manually fine-tune inputs to remove process offset errors or system scale
errors.
Note.

Changes to the Analog Input Type (see page 96) must be saved to
the current configuration before commencing input adjustment.

For dual input modules, 2 channels can be adjusted.
7 Configuration
117