ABB SM500F User Manual page 2

The Company
We are an established world force in the design and manufacture of instrumentation for
industrial process control, flow measurement, gas and liquid analysis and environmental
applications.
As a part of ABB, a world leader in process automation technology, we offer customers
application expertise, service and support worldwide.
We are committed to teamwork, high quality manufacturing, advanced technology and
unrivalled service and support.
The quality, accuracy and performance of the Company's products result from over 100
years experience, combined with a continuous program of innovative design and
development to incorporate the latest technology.
Electrical Safety
This equipment complies with the requirements of CEI/IEC 61010-1:2001-2 'Safety Requirements for Electrical
Equipment for Measurement, Control and Laboratory Use'. If the equipment is used in a manner NOT specified by
the Company, the protection provided by the equipment may be impaired.
Symbols
One or more of the following symbols may appear on the equipment labelling:
Warning – Refer to the manual for
instructions
Caution – Risk of electric shock
Protective earth (ground) terminal
Earth (ground) terminal
Information in this manual is intended only to assist our customers in the efficient operation of our equipment. Use of
this manual for any other purpose is specifically prohibited and its contents are not to be reproduced in full or part
without prior approval of the Technical Publications Department.
Health and Safety
To ensure that our products are safe and without risk to health, the following points must be noted:
1. The relevant sections of these instructions must be read carefully before proceeding.
2. Warning labels on containers and packages must be observed.
3. Installation, operation, maintenance and servicing must only be carried out by suitably trained personnel and in accordance
with the information given.
4. Normal safety precautions must be taken to avoid the possibility of an accident occurring when operating in conditions of
high pressure and/or temperature.
5. Chemicals must be stored away from heat, protected from temperature extremes and powders kept dry. Normal safe
handling procedures must be used.
6. When disposing of chemicals ensure that no two chemicals are mixed.
Safety advice concerning the use of the equipment described in this manual or any relevant hazard data sheets (where applicable)
may be obtained from the Company address on the back cover, together with servicing and spares information.
Lenno, Italy – Cert. No. 9/90A
Direct current supply only
Alternating current supply only
Both direct and alternating current supply
The equipment is protected
through double insulation
EN ISO 9001:2000
Cert. No. Q 05907
EN 29001 (ISO 9001)
Stonehouse, U.K.