Setting The Time; Before First Use - Silvercrest SKA 1000 A1 Operating Instructions Manual

Setting the time

1) Press the AUTO/PROGRAMM button
2) Within 10 seconds, press the STD button
in hours:
–
press the STD button
shown in the display
Alternatively,
–
Press and hold the STD button
hours. This will cause the hour display to cycle faster.
3) Once you have set the desired number of hours, press the MIN button
order to set the minutes:
–
Press the MIN button
is shown in the display
Alternatively,
–
Press and hold the MIN button
minutes. This will cause the minute display to cycle faster.
4) Once you have set the desired time, wait for 10 seconds without pressing any
buttons. The display
Before first use
CAUTION – PROPERTY DAMAGE!
► Never fill more than 8 cups of water into the water tank
► A small hole is located on the back of the appliance. It is a water overflow
which prevents excessive amounts of water from being filled into the machine.
If the water level exceeds the MAX mark, the water will escape through the
water overflow
► If the water tank
water may spill through the water overflow
► Never fill the water tank with less than 2 cups of water
Use the water level gauge
1) Unscrew the lid
2) Carefully rinse the vacuum flask
3) Open the appliance lid
SKA 1000 A1
. The display
repeatedly until the desired number of hours is
.
until you reach the desired number of
repeatedly until the desired number of minutes
.
until you reach the desired number of
will no longer show CLOCK. The time has been saved.
onto the worktop.
is full (8 cups of water) and the appliance is moved,
on the water tank
and remove it from the vacuum flask
with water.
and remove the filter holder
will read CLOCK.
in order to set the desired time
(MAX mark).
.
.
.
.
from the appliance.
GB
│
in
,
23 ■