Basic Procedure For Dme Wipe Settings; Dme Wipe Settings Menu; Dme Wipe Pattern Selection - Sony DVS-9000 User Manual

With ccp-8000 series center control panel

Hide thumbs Also See for DVS-9000:

Table of Contents

Basic Procedure for DME Wipe Settings

You carry out DME wipe setting operations principally using the DME Wipe

menu for each bank.

This section describes the basic procedures for DME wipe settings, taking the

M/E-1 >DME Wipe menu as an example.

For details of independent key transition DME wipe settings, see "DME Wipe

Settings for Independent Key Transitions" (page 334).

• To carry out DME wipes requires the BKDS-9470 DME Board Set or the

MVE-8000A/9000 DME Processor.

• For one M/E bank, DME effects (including external processed keys) can be

used in up to two places on the DME dedicated interface and in only one

place on the SDI interface simultaneously.

Accessing the DME Wipe menu

To access the M/E-1 >DME Wipe menu, use either of the following operations.

• In the menu control block, select the top menu selection button [M/E 1], and

press VF6 'DME Wipe.'

• In the transition control block of the M/E-1 bank, press the transition type

selection button [DME] twice in rapid succession.

Either of the above operations displays the M/E-1 >DME Wipe menu.

Selecting a DME wipe pattern by a menu operation

In the M/E-1 >DME Wipe menu, select HF1 '1ch' for one-channel mode,

HF2 '2ch' for two-channel mode or HF3 '3ch' for three-channel mode.

Select the desired DME wipe pattern group with one of the following

• Slide/Squeeze: slide and squeeze