can make all the internal signals of the switcher selectable by a setting in
the Setup menu.
For details, see "Selecting the Bank to Make the Settings" in Chapter 20
(Volume 3).
Selecting the color corrector output signal
By assigning the signal output from the color corrector to a cross-point button,
you can make that signal available on that button.
For details of the assignment process, see "Cross-Point Settings (Xpt Assign
Menu)" in Chapter 19 (Volume 3).
Accessing the CCR menu
For color correction operations, use the CCR menu.
To access the CCR menu, in the menu control block, press the top menu
selection button [CCR].
The following description uses CCR1 as an example. To apply color correction
to CCR2, replace VF1 'CCR1' by VF2 'CCR2,' and follow the same
procedure.
423
Preparations