Sony DVS-9000 User Manual page 796

With ccp-8000 series center control panel

Hide thumbs Also See for DVS-9000:

Table of Contents

Recalling a snapshot in the Flexi Pad control block (standard

type or simple type)

When an M/E bank is not assigned to any region selection button in the

numeric keypad control block in a setup setting, it is not possible to recall a

snapshot with the Flexi Pad control block of that M/E bank. (See "Assigning a

Region to a Region Selection Button in the Numeric Keypad Control Block" in

Chapter 19 (Volume 3).)

As an example, to recall a snapshot on the M/E-1 bank, use the following

Snapshot Operations in the Flexi Pad Control Block

Not lit: register not containing anything

To apply an attribute, hold down the [SNAPSHOT] button, and in the

memory recall section, press a button as follows, turning it on.

Attribute to apply

Effect dissolve

Auto transition

For details of attributes, see "Snapshot Attributes" (page 785).

In the Flexi Pad control block, it is not possible to apply the cross-point

hold or GPI output attributes. In a simple type Flexi Pad control block, it

is not possible to apply any attributes. To add these attributes, use a menu

operation. (See page 806.)

Still holding down the [SNAPSHOT] button from step 4, press the

memory recall button corresponding to the register in which you want to

In the M/E-1 bank Flexi Pad control block, press the [SNAPSHOT] button.

This assigns the Flexi Pad control block to snapshot operations. The

numeric display shows the last selected bank number and the register

number last recalled on the bank.

Select the bank for recall.

See step 3 (page 795) in "Saving a snapshot in the Multifunction Flexi Pad

control block."

[EFF DISS] button

[AUTO TRANS] button