Netconf Commands; Xml - HP FlexFabric 12500 Series Network Management And Monitoring Command Reference

NETCONF commands

The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for features,
commands, and parameters might differ in FIPS mode and non-FIPS mode. For more information about
FIPS mode, see Security Configuration Guide.

xml

Use xml to enter XML view.
Syntax
xml
Views
User view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Usage guidelines
In XML view, you can use NETCONF messages to configure the device or obtain data from the device.
NETCONF operations you can perform depend on the user roles you have, as shown in
Table 39 NETCONF operations available for the predefined user roles
User role
•
network-admin
•
mdc-admin
•
network-operator
•
mdc-operator
NETCONF messages must comply with the XML format requirement and the XSD file semantic and
syntactic requirements. To ensure successful configuration, HP recommends that you use third-party
software to generate NETCONF messages.
To quit XML view, use a NETCONF message instead of the quit command.
If you have configured a shortcut key (Ctrl + C, by default) by using the escape-key command in user
line/user line class view, the NETCONF message should not contain the shortcut key string. Otherwise,
relevant configurations in XML view might be affected. For example, suppose that in user line view, you
NETCONF operations
All NETCONF operations
•
Get
•
Get-bulk
•
Get-bulk-config
•
Get-config
•
Get-sessions
•
Close-session
178
Table 39.