Lsr-Path; Mode - HP FlexFabric 12500 Series Network Management And Monitoring Command Reference

Usage guidelines
If the number of history records for an NQA operation exceeds the maximum number, earliest history
records are removed.
Examples
# Set the maximum number of history records for an NQA operation to 10.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] history-record number 10

lsr-path

Use lsr-path to set a loose source routing (LSR) path.
Use undo lsr-path to restore the default.
Syntax
lsr-path ip-address&<1-8>
undo lsr-path
Default
No LSR path is configured.
Views
Path jitter operation view
Predefined user roles
network-admin
mdc-admin
Parameters
ip-address: Specifies a space-separated list of up to 8 IP addresses. Each IP address represents a hop on
the path.
Usage guidelines
The path jitter operation uses tracert to detect each hop to the destination, and sends ICMP echo requests
to measure the delay and jitters from the source to each node. If multiple routes exist between the source
and destination, the operation uses the path specified by using lsr-path command.
Examples
# Specify 10.1.1.20 and 10.1.2.10 as the hops on the LSR path for the path jitter operation.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type path-jitter
[Sysname-nqa-admin-test- path-jitter] lsr-path 10.1.1.20 10.1.2.10

mode

Use mode to set the data transmission mode for the FTP operation.
41