Parameter Window General - ABB i-bus KNX Product Manual


ABB i-bus KNX
Commissioning
3.2.1

Parameter window General

In this parameter window, the main parameter settings relevant for the entire DALI Light Controller are
undertaken.
Use copy function to copy or
exchange light groups
(Open by right-clicking device
in the ETS topology)
<−−− NOTE
Enable manual operation
Object "Block manual operation/Status"
Options:
This parameter defines if the switch over between the operating states Manual operation and KNX
operation is enabled or disabled via the

Yes: The communication object Block manual operation/Status is enabled.
Telegram value:
Note
Blocked manual operation is re-enabled on KNX voltage recovery or after a download.

No: Manual operation is generally disabled. The communication object Block manual operation/Status
is not enabled.
Yes
No
0 = Enable button
1 = Block button
button on the device.
DLR/S 8.16.1M | 2CDC 507 100 D0202 43