Bosch IRIS-Net User Manual page 498

IRIS-Net
Audio Interface Faults
Error
Boot
Delay RAM
Watchdog
Pilot Tone Detection
R/W Base Config
R/W Config
Invalid Config
R/W Preset
Invalid Preset
Incompatible Preset
OS Memory
HW Config Slot 1
HW Config Slot 2
HW Config Slot 3
HW Config Slot 4
HW Config Ext. Slot
HW Config Cobranet
Cobranet Interface
Bosch Security Systems B.V.
Description
Booting the DSP system failed, Audio Processing is not possible. Please refer to the
correspondent Log File entries
Delay RAM fault. Audio Processing using the concerned RAM areas is not possible. Please
refer to the correspondent Log File entries
One processor of the DSP system signals the occurrence of an error. Please refer to the
correspondent Log File entries
At least one of the pilot tone detections in the N8000's DSP configuration is not able to
detect the pilot signal
Error while reading or writing the DSP Base Configuration
Error while reading or writing the DSP Configuration
Unable to process invalid DSP Configuration
Error while reading or writing a DSP Preset
Unable to process an invalid DSP Preset
Selected DSP Preset and current DSP Configuration are not compatible
An error occurred when the operating system of the N8000 tried to access the memory
The DSP configuration of Audio Slot 1 does not represent the actual hardware configuration
The DSP configuration of Audio Slot 2 does not represent the actual hardware configuration
The DSP configuration of Audio Slot 3 does not represent the actual hardware configuration
The DSP configuration of Audio Slot 4 does not represent the actual hardware configuration
The DSP configuration requires an extension board connected to the extensions port, but
there is no board connected
The DSP configuration requires a CobraNet board installed in the network module slot, but
there is no board installed
An error occurred during communication with the CM-1 interface
User Manual
DIGITAL MATRIX | en 498
2017.05 | 3.20 | F.01U.119.956