Bosch IRIS-Net User Manual page 949

IRIS-Net
NUMBER OF ANALOG VALUES
IS ALIVE PERIOD (s)
PASSWORD
FPA 5000 INTERFACE
ENABLE
TCP Port
USERNAME
PASSWORD
CONTROL IN
STATE
VOLTAGE
FAULT MON
ACTIVE
OK
CONTROL OUT
STATE
PowerManagement Dialog
The Power Management dialog allows configuring the standby mode of the device in detail.
Bosch Security Systems B.V.
Enter the number of analog values of the task engine to be available via the ASCII
control protocol.
Enter the "is alive period" of the ASCII control protocol in seconds.
If password protection of the ASCII control protocol is required, enter the
password here. Repeat the password in the CONFIRM PASSWORD field. Go
online (write) to set the password in the device.
HINT: Editing the password setting is possible in offline mode only.
Set the checkbox to activate the connection between a FPA 5000 and the
PVA-4CR12 via Ethernet. Available only for PVACON_1
TCP port of the FPA 5000 interface. The default port is 9401.
Enter the username defined in the FPA.
Enter the password defined in the FPA.
Displays the control inputs' current state.
Displays the control inputs' current voltage.
Set the checkbox of supervised control inputs to activate the supervision.
Set the upper and lower bound (voltage) of the ACTIVE state of the supervised
control inputs.
Set the upper and lower bound (voltage) of the OK state of the supervised
control inputs.
It is possible to manually change the condition of the control outputs (normally
open contact / normally closed contact).
User Manual
PAVIRO | en 949
2017.05 | 3.20 | F.01U.119.956