Editing Network Settings; Searching Omneo-Devices On The Ethernet - Bosch IRIS-Net User Manual

IRIS-Net
NETWORK Shows the network settings of the device in the format: IP address / subnet mask GW: gateway
SETTINGS address
SYSTEM NAME Shows the system name of the device
SOFTWARE Shows the firmware version of the device
VERSION
IRIS-Net If a device is part of the current project, this column shows the name assigned to the device in this
specific project.
Starts a search for devices on the Ethernet network.
Use this button to restart the device that has been selected in the devices list. Before the device
restarts, a dialog box appears, asking the user to enter user name and password.
Use this button to configure the device that has been selected in the devices list. Pressing the
CONFIG button opens the Config dialog box.
Clicking onto this button closes the Device Scan dialog.

Editing network settings

Double click at the network settings of a device in the Devices list to open the dialog for editing the network settings.
Following table lists the default username and password for supported devices.
Device
N8000
P 64
DPM 8016
DPM 8016
PVA-4CR12
PMX-4CR12

Searching OMNEO-devices on the Ethernet

The OCA Scan dialog allows configuration of OMNEO-devices that are accessible from the PC via Ethernet.
HINT: Firewalls can cause problems when using the OCA Scan dialog.
Selecting the entry OCA Scan in the Tools menu lets you access the OCA Scan dialog.
Bosch Security Systems B.V.
Firmware version
all
all
< 1.16.0
>= 1.16.0
all
all
Default user name
netmax
netmax
dpm
admin
admin
admin
User Manual
IRIS-Net | en
Default password
netmax
netmax
dpuser
0000
0000
0000
2017.05 | 3.20 | F.01U.119.956
66